Showing 1–9 of 62 results
-
4-pole fuse holder cap, 1 unit, accessory for: 3VA1 100/160
Add to quote4-pole fuse holder cap, 1 unit. Accessories for: 3VA10/11 Molded-case circuit breakers 3VA SENTRON: a system. For any application.
-
4-pole terminal cover, 1 unit, accessory for: 3VA1 250
Add to quote4-pole terminal cover, 1 pc. accessories for: 3VA12 Molded-case circuit breakers 3VA SENTRON: a system. For any application.
-
Cover for exposed connections, yellow
Add to quoteProtection against contact for exposed connections, yellow. SENTRON 5ST3 busbar systems as an optional component for residual current devices and circuit breakers. This…
-
End cap for 1-phase pin header
Add to quoteCap for single-phase busbar pin systems SENTRON 5ST3 as an additional component for residual current devices and circuit breakers. These additional components can be attached universally. They can be mounted and connected in a convenient and straightforward way. Thanks to the built-in protection against direct contact, safety during installation is guaranteed. Optimum technology for your safety, only from Siemens.
-
Plug block protected against direct contact, 16 mm2 2-pole + auxiliary switch, 214 mm long, with end caps
Add to quotePlug block protected against direct contact, 16 mm2, 2-pole + auxiliary switch, 214 mm long, with SENTRON 5ST3 pin strip end caps as an additional component for residual current devices and circuit breakers (RCDs/BIs) for installation…
-
Terminated plug protected against direct contact, 16 mm2 1 phase + auxiliary switch, 1016 mm long, cuttable, without process clamps
Add to quoteTerminated plug protected against direct contact, 16 mm2 1 phase + auxiliary switch, 1016 mm long and cuttable, without process clamps; pin bus SENTRON 5ST3 as an additional component for…
-
PATG 1/15 / Wire labeling support
Add to quoteWire labeling support, transparent, unlabeled, Mounting type: extend, Cable diameter: 1.5-2.5 mm, Useful surface: 4 x 15 mm
-
PATG 2/15 / Driver signage support
Add to quoteConductor signage support, transparent, unlabeled, Mounting type: extendable, Cable diameter: 2-4 mm, Useful surface: 4 x 15 mm
-
PATG 0/15 / Driver signaling support
Add to quoteDriver signaling support, transparent, unlabeled, mounting type: extend, cable diameter: 0.6-1.2 mm, working surface: 4 x 15 mm
